With a Push Button Control Method, a small button is installed under the sinks or at specific locations in the home. With the Touch of a Button the Water Pump goes to work, circulates the Hot Water for a necessary 2 to 3 minutes, and automatically shuts OFF, saving Gas or Electric Energy to heat the water.

Installation: In New Home Construction, prior to wall boarding, the Electrician has the ability to run wires throughout the Home. This would be the best time to run (bell) wiring from all points in the home to where the Hot Water Heater will be placed. This would also be a good time to run a "Dedicated Return Line"(That is, a special piece of pipe running from the Hot Water Heater to the sink or sinks that are furthest away from the Hot Water Heater).

The ideal time to hook up all wires to the Master Control Unit and Install the Water Pump Motor is when the New Home is Completed.

NOTE: In the event the water pump motor has been simply plugged into the AC Outlet and allowed to run at all times, a definite increase in Gas or Electric Energy will be the end result.

Click on the link to see more.